Marantz 1060 Complete Rebuild Kit High-Quality Amplifier Recap Transistors

Description

Up for sale here is this complete rebuild kit for a Marantz 1060 amplifier.  This includes all the parts you need to rebuild the Marantz 1060 power supply board, amplifier board, phono EQ board, and preamp board, plus it includes upgraded replacement main capacitors, a new blue LED, and a new power switch with snubber capacitor.  This does not include new fuses or output transistors.  The correct replacements for the original output transistors are MJE21194G, which I have available
here
.  Please do not buy any of the fake "Made in Japan" Chinese output transistors listed on eBay--these are counterfeit and will damage your amp.
This kit includes the following:
Power Supply Board:
4 capacitors
2 diodes
1 transistor
Amplifier Board:
12 capacitors
6 transistors
4 trimmers
Phono EQ Board:
9 capacitors (2 extra to account for board variations)
6 transistors
Preamp Board:
13 capacitors
8 transistors
3 new main capacitors (2 are same diameter as the old caps so they will fit the clamps, upgraded uf/voltage rating)
1 mounting clamp (for third cap to replace giant capacitor)
Power switch w/ snubber capacitor & knob
Wired blue LED (I can substitute an incandescent bulb if you prefer, just let me know)
Instructions
The kit for each board is bagged individually to make things easier.
These are all high-quality brand new genuine parts.  The main capacitors are Nichicon LS 6800 uf 80v caps, the other capacitors are 105° Panasonic FC, Nichicon PW, Nichicon KL, and Wima film caps at the same uf ratings and the same or higher voltage ratings, and the transistors and diodes are the correct Fairchild/Onsemi subs for the original transistors.  These are not cheap Made in China parts, they are extremely high-quality and they are what I use when I rebuild Marantz equipment.  The two smaller main caps have drop-in replacements, but the third giant one (on the right) is replaced with a physically smaller cap plus a new clamp to mount it properly.  The chassis has holes already there for this new cap--you will need to provide two small sheet-metal screws to mount it, plus reuse the nut/bolt from the old clamp.
I will include surprisingly well-written instructions, but rebuilding an amplifier is moderately complicated, and you should know what you're doing and have a decent soldering iron and a dim-bulb tester with a 60W or 100W incandescent bulb.  Please see my pictures for details.
US shipping and handling is , and international is .  If you have any questions, please ask.
Looking for more parts?  I have
power switches
,
feet
,
pushbuttons
,
top case screws
,
bottom screws
,
faceplate screws
,
white LED fuse lamps
,
blue LED fuse lamps
,
6.3v bi-pin bulbs
,
8v bi-pin bulbs
,
12v bi-pin bulbs
,
wired 8v 60ma bulbs
,
new power cords
,
new main capacitors for the Marantz 1060/2230
,
wired Pioneer speaker plug replacements
,
new 630v yellow film capacitors at 13 different values
,
a large variety of transistors for vintage stereo repair,
and more.  Just use "add to cart" on everything you want and then check out for combined shipping.